机器程序文件.docx

《机器程序文件.docx》由会员分享，可在线阅读，更多相关《机器程序文件.docx（1页珍藏版）》请在第一文库网上搜索。

1、TITLE标题:射骨机操作指引INITIATOR 启动：QA MANAGER :SkyDATE日期4/12/2021EFFECTIVE DATE实施日期4/12/2021DOCUMENT NO.文件号码M-lAPPROVED Jtt 准人GEN. MANAGER: JudeDATE日期4/12/2021EFFECTIVE DATE实施日期4/12/2021VERSION版本：1REVISION REASON 翻新原因A. RELEASE发彳亍1.组长打开射骨机器，调节温度开关至正常范围200-300oc,并检查其它功能，如：压力开关和定时器等。把所有参数按参数表设定正确。The group l

2、eader turns on the VID machines, switches the temperaturecontrol (normal at 200-300) and check other functions, such as,pressure control and timer.2 .打开模具(已经安装在机器上)，让塑料流一会儿，直到颜色和生产样板的颜色一样为止。Open the mould (already fixed on the machines) and let the plastic bleedfor a while until the color is the sam

3、e as the productionsample.3 .启动安全双制开关并测试模具：看产品上是否有废料，把机器压力调到适当范围，然后准备开机。Press the safety double switch buttons and test moulds: if there isexcessive plastic on the item and adjust the machine pressure to aproper range and ready to turn on the machines.4 .不需要使用机器时，把温度控制器调到3并关掉所有的开关。Set the temperature control to zero and turn off all the switches whenthe machines need not to be used.