《Creo Elements Direct18.1 基本建模培训教程Drawing from Paddle and Drum.docx》由会员分享，可在线阅读，更多相关《Creo Elements Direct18.1 基本建模培训教程Drawing from Paddle and Drum.docx（3页珍藏版）》请在第一文库网上搜索。
1、f In below mail, I wrote down the link between 3D model and annotation drawing of item 947159305 isbreak.f The items which save drafting in the master data like below picture:947158305947158205959529505Answer: 947158305Create a Drawing from the model (red) and copy the remaining drawing (blue) as sk
2、etch from ME10940474705 is a special model.Geometry was determined in a prototype construction. This construction was measured by a 3Dmeasuring system. This system gives out a 3D-Point Matrix. We create a Face Model with these points andmerge it to a volume model. The same we did with the 2D-drawing
3、.You could try to create the side view (red) from the Model and copy the remaining drawing (blue) assketch from ME10947158805947159005947159205947159405947159605947159905947160105947160405948557405This Model has a Stock and Finish relation. You could use the Stock Model to create the Flatview (red) andK7u-ucopy the remaining drawing (blue) as sketch from ME10. The left blue view is only to control the producedpart, you cant get it from the model.
免费区 
